Cap Bottom Assy Block - Sony NW-A100TPS Service Manual

NW-A100TPS/A105/A105HN/A106HN
2-9.

CAP BOTTOM ASSY BLOCK

top side
cabinet block
1 Peel off the key FPC from the sheet adhesive OBC.
Note 1: When installing the key FPC, don't press with
the nails of the fingertip or bend with the tweezers.
Note 2: When installing the key FPC, align the two
bosses and two holes.
key FPC
hole
sheet
adhesive
OBC
boss
36
rear side
bottom side
connector
(CN1001)
6 Lift up the cap bottom assy
block in the direction of the
arrow.
Note of installing the HP FPC
Be careful following points when bending of the HP FPC, installing
to the connector.
Don't press with the nails of the fingertip or bend with the tweezers.
When inserting the HP FPC to the connector, insert it straight into the
interior.
When locking the connector of the HP FPC, press the center of the
lock plate.
Check the connector of the HP FPC is completely locked or connected.
3 Unlock the connector (CN1001).
4 Draw out the HP FPC
2 sheet (ENT)
8 cap bottom assy block
Note 3: When installing the cap bottom assy
groove
7 Remove the cap bottom assy
block in the direction of the
arrow.
Sony CONFIDENTIAL
For Authorized Servicer
bottom side
terminal side
from the connector.
5 two screws (NDS-EL)
(M1.4) (L = 4.0 mm)
block, align the pin strap (shaft) and
hole, two grooves and two ribs.
groove
hole
pin strap (shaft)
rib
connector
(CN1001)
HP FPC
rib
SYS SET