Sony NW-A100TPS Service Manual page 45

NW-A100TPS/A105/A105HN/A106HN
5-2-8. Normalizer check (Normalizer)
Note: Not used for the servicing.
5-2-9. Sound pressure regulation level check
(Sound pressure)
Note: Not used for the servicing.
5-2-10. Playback user fi le 1 (Play user fi le-1)
Note: Not used for the servicing.
5-2-11. Playback user fi le 2 (Play user fi le-2)
Note: Not used for the servicing.
5-2-12. Playback user fi le 3 (Play user fi le-3)
Note: Not used for the servicing.
5-2-13. Playback SD-card fi le 1 (Play SD-card fi le-1)
Note: Not used for the servicing.
5-2-14. Playback SD-card fi le 2 (Play SD-card fi le-2)
Note: Not used for the servicing.
5-2-15. Playback SD-card fi le 3 (Play SD-card fi le-3)
Note: Not used for the servicing.
5-2-16. Playback user select (Play user select)
Note: Not used for the servicing.
45
5-2-17. Hi-Res output (Output HiRes check)
It can be output the "Sampling rate: 192 kHz/Frequency: 1 kHz
(L/R-ch)/Bit rate: 32 bit" audio signal for the Hi-Res check.
Procedure:
1. Press the [+] or [–] button to select the "Audio", and press the
[ ] or [ ] button to enter the minor item.
u >
2. Press the [+] or [–] button to select the "Output HiRes check".
3. Press the [ ] button, the audio signal output screen is dis-
u
played and enter an arbitrary value.
(For the buttons operation for setting, refer to "Common button
input setting of the audio item" on page 43)
Screen display
Audio
(AUD HIRS command)
Audio HiRes
output [SE]
volume [ 90]
[60]
play time
4. Press the [ ] button, and output an audio signal using the set-
u
tings selected.
5. Switch the [HOLD] switch in the order of OFF t ON, or ON
t OFF t ON, to return to minor item selection screen.
5-2-18. HP (BTL) gain setting (HP (BTL) gain)
Note: Not used in this unit.
5-2-19. HP (SE) gain setting (HP (SE) gain)
Note: Not used in this unit.
5-2-20. Headphone check (HP check)
Note: Not used for the servicing.
5-2-21. LPA check (LPA check)
Note: Not used for the servicing.
Sony CONFIDENTIAL
For Authorized Servicer
Item of button input settings
SYS SET