Sony NW-A100TPS Service Manual page 17

NW-A100TPS/A105/A105HN/A106HN
5-3-3. Checking the PC confi guration setting
Check that the operation confi guration is set correctly to the using
PC for execute the pre-installed content setting.
Checking procedure:
All of "Checking the PC confi guration setting" will operate on the
PC.
1. Double click "2_adb_check.bat" in the "NWA100ZX500_Init_
ServiceTool_1.00.00" folder.
NWA100ZX500_
Init_ServiceTool_
x.xx.xx
2. Check the "Android Debug Bridge version" fi eld on the display
screen.
Note 1: If operation confi guration is not setting on the PC, sentences with
unrecognized content will be displayed.
In that case, refer to "5-3-2. PC confi guration setting" on page 16
and make the settings.
Note 2: If the version is "1.0_xxx" or later, it is set normally.
3. Press any key on the PC keyboard and close the display screen.
4. Complete the checking the PC confi guration setting.
This completes the checking the PC confi guration setting.
Refer to "5-4. Perform pre-installed content setting" on the right and
perform the pre-installed content setting.
17
1_java_check.bat 2_adb_check.bat adb-setup-1.4.3.exe
check
5-4. Perform pre-installed content setting
Write the pre-installed content on the WALKMAN main unit.
Used tool (folder name):
Pre-installed content
Note 1: Select and use the folder of the color name that conforms to
body color.
Except CH
Folder name
NW-A100_Contents_WW_Black
NW-A100_Contents_WW_Blue
NW-A100_Contents_WW_Green
NW-A100_Contents_WW_Orange
NW-A100_Contents_WW_Red
CH
Folder name
NW-A100_Contents_CN_Black
NW-A100_Contents_CN_Blue
NW-A100_Contents_CN_Green
NW-A100_Contents_CN_Orange
NW-A100_Contents_CN_Red
Pre-installed content setting tool
NWA100ZX500_TransferTool_x.xx
Note 2: When checking the destination of this unit, refer to "WALKMAN
MAIN UNIT IDENTIFICATION METHOD" on page 7.
Note 3: "x.xx" of tool name indicates the version. Be sure to use the latest
version.
Procedure:
1. Connect the WALKMAN main unit to a PC that has already
been set up with a PC operation confi guration by the USB Type-
C cable.
(The power supply of the WALKMAN is automatically turned
on and test mode state)
Note 4: If leave the connection status in the previous step, this step is not
necessary.
– The following steps are performed on the PC –
2. Open the folders the pre-installed content and the pre-installed
content setting tool.
3. Copy the "opt2" and "opt3" folders in the pre-installed content
folder to the pre-installed content setting tool.
In the pre-installed
content folder
4. In the non-selected state for fi les in the pre-installed content set-
ting tool folder, and put a cursor to blank space in the folder.
In the pre-installed content setting tool folder
blank space cursor
Sony CONFIDENTIAL
For Authorized Servicer
Body color
Black
Blue
Ash Green
Orange
Red
Body color
Black
Blue
Ash Green
Orange
Red
USB Type-C cable
In the pre-installed content
setting tool folder
copy
– Continued on next page –
SYS SET