Sony NW-A100TPS Service Manual page 18

NW-A100TPS/A105/A105HN/A106HN
Ver. 1.2
5. The right-click while pressing the Shift key in the state of step 4.
6. Select the "Open PowerShell window here" from the displayed
menu, and launch the PowerShell application software.
7. Input the following command and press the Enter key.
".\optcopy_adb.bat"
Note 5: An error may be displayed when connecting for the fi rst time. In
that case, enter the ".\optcopy_adb.bat" command again and press
the Enter key.
PS C:\Users\xxxx\Desktop\xxxx>.\optcopy_adb.bat
Tool folder name
8. Check that the following fi gure message has been displayed, and
input "y", and press the Enter key.
Input
9. The pre-installed content setting for the WALKMAN main unit
is executed, and when completed, the message "COMPLET-
ED." is displayed.
(Displayed characters/values in the following fi gure are exam-
ple)
Note 6: It takes time to fi nish writing. Never disconnect the USB Type-C
cable while writing.
PS C:\Users\xxxx\Desktop\xxxx>_
10. Close the PowerShell window.
This completes the Pre-Installed content setting.
Perform "6. Factory Setting Firmware Writing" while keeping the
test mode menu screen is displayed.
Note: Make sure that "3. Perform Each Test Mode", "4. Each Initial Setting"
and "5. Pre-Installed Content Setting" are correctly completed before
performing "6. Factory Setting Firmware Writing".
18
6. Factory Setting Firmware Writing
Write the fi rmware to set the WALKMAN main unit to the product
state.
IMPORTANT NOTE
Be sure to perform each test mode and each initial setting are
complete before factory setting fi rmware writing.
When factory setting fi rmware writing is started, each test mode
and each initial setting cannot be performed.
6-1. Advance preparation
a. Windows PC (OS: Windows 10 or later)
b. USB Type-C cable (USB-A y USB-C)
c. Factory setting tool
Input
Note 1: When checking the destination of this unit, refer to "WALKMAN
Note 2: The PC confi guration setting tool performed in "5. Pre-Installed
Note 3: "x.xx.xx" of each tool name indicates the version. Be sure to use
Note 4: Confi rm with each service headquarters for the obtaining method of
Note 5: Factory setting tool, be sure to used by OS of Windows 10 or later.
(OS: Windows
Destination
icx1293-04.00.P.x.xx.xx-001-user-installer-
AEP, UK
releasekeys.zip
US, CND, E, icx1293-04.00.P.x.xx.xx-002-user-installer-
AUS, KR, LA releasekeys.zip
icx1293-04.00.P.x.xx.xx-003-user-installer-
EE
releasekeys.zip
icx1293-04.00.P.x.xx.xx-004-user-installer-
TW
releasekeys.zip
icx1293-04.00.P.x.xx.xx-005-user-installer-
CH
releasekeys.zip
MAIN UNIT IDENTIFICATION METHOD" on page 7.
Content Setting" is not required. The factory setting fi rmware can
be written on a normal Windows PC (OS: Windows 10 or later).
the latest version.
factory setting tool and its latest version.
a. Windows b. USB Type-C
PC cable
(USB-A y USB-C)
10 or later)
Sony CONFIDENTIAL
For Authorized Servicer
Tool
c. Factory set-
ting tool
SYS SET