Table of Contents
Advertisement
4x1 4K60 HDMI Switch with Control and Audio Extraction
3.1 Configuration
Connect all video sources to the VIDEO IN connectors
•
Connect the display device to the OUTPUT connector
•
Connect the Power Supply to the power input
•
Connect any external controller or PC to the RS-232 terminal block, if required.
•
Connect IP-CTRL port to compatible LAN network, if required.
•
Connect IR detector to external IR CTRL port, if required.
•
4.0 Operation
The unit can be controlled via front panel and via external control options like IR remote
control, RS-232, Telnet and/or the Web GUI.
Press the desired INPUT button switch to display the available video on the HDMI output.
•
The illuminated LED shows which input is directed to the OUTPUT connector.
•
Press and hold INPUT button #1 for 7 seconds, then release to factory reset the unit to
•
default settings.
Press and hold INPUT button #4 for 7 seconds to start cycling through each input at a 1-
•
minute rate
Press and hold INPUT button #4 for 11 seconds to stop cycling through each input.
•
The USB port can be used for firmware upgrades or powering external devices.
•
The IR remote control supplied with the unit can be used to select the desired HDMI
•
INPUT, MUTE the HDMI OUTPUT audio or turn the system on or off (Unit will always be
ON after a power cycle).
6
Advertisement
Table of Contents
