Clearances And Dimensions - IKEA CIRKULERA Manual

Clearances and Dimensions

1. Provide adequate clearances between the range
and adjacent combustible surfaces.
2. Location—Check location where the range will be
installed. Check for proper electrical supply, and
the stability of the floor.
3. Dimensions that are shown must be used. Given
dimensions provide minimum clearance. Contact
surface must be solid and level.
FRONT
VIEW
Minimum to wall
on either side of
range above
36'' (914 mm)
height.
36"
(92 cm)
Fig. 3
*30" Minimum clearance between the top of the cooking surface and the bottom of an unprotected wood or
metal cabinet
24" minimum when bottom of wood or metal cabinet is protect by not less than 1/4" flame retardant mill-
board covered with not less than No. 28 MSG sheet steel, 0.015" stainless steel, or 0.024" aluminum or
0.020" copper.
0" clearance is the minimum for the rear of the range. Follow all dimension requirements provided above to
prevent propery damage, potential fire hazard, and incorrect countertop and cabinet cuts.
To eliminate the risk of burns or fire be reaching over heated surface units, cabinet storage space located
above the surface units should be avoided. If cabinet storage is to be provided, the risk can be reduced by
installing a range hood that projects horizontally a minimum of 5" beyond the bottom of the cabinets.
24"
(61 cm)
30"
(76 cm)
Minimum
1"
(2.5 cm)
24"
(61 cm)
28-3/4" with
door handle
23.5" 23⅝"
60 cm 60 cm
48"
maximum
35⅞ - 36⅞"
91.1 - 93.7 cm
49"
door open
maximum
Fig. 1
Minimum to
cabinets on
18"
either side of
(46 cm)
range.
0" (0 mm) clearance below cooking top and at rear of range.
29 1/4" with
door handle
26-3/8"
25-3/4" All dimensions for electrical outlet location
41.5"
shows where the electrical outlet must be
105 cm
Maximum
door open
24"
(61 cm)
(25 cm)
3-3/4" (9.5 cm)
SIDE
VIEW
13"
15"
38 cm
33 cm
Maximum depth
for cabinets
above range top.
25"
64 cm
are maximum.
Shaded area
installed
for flush to the wall installation.
10"
Wall
Edge
Fig. 2
5