IKEA CIRKULERA Manual page 6

NORMAL INSTALLATION STEPS
1. ANTI-TIP BRACKET INSTALLATION
INSTRUCTIONS - IMPORTANT SAFETY
WARNING
To reduce the risk of tipping of the range, the range
must be secured to the floor by properly installed
Anti-Tip Bracket and screws packed with the range.
Failure to install the anti-tip bracket will allow the
range to tip over if excessive weight is placed on an
open door or if a child climbs upon it. Serious injury
might result from spilled hot liquids or from the
range itself.
If range is ever moved to a different location, the
Anti-Tip Bracket must also be moved and installed
with the range.
Instructions are provided for installation in wood
or cement fastened to either the floor or wall.
When installed to the wall, make sure that screws
completely penetrate dry wall and are secured in
wood or metal. When fastening to the floor or wall,
be sure that screws do not penetrate electrical
wiring or plumbing.
1a. Locate the Bracket using the Template -
(Bracket may be located on either the left or right
side of the range. Use the information below to
locate the bracket if template is not available).
Mark the floor or wall
where left or right side
of the range will be
located. If rear of range
is against the wall or no
further than 1-1/4" from
wall when installed, you
may use the wall or floor
mount method. If molding is installed and does
not allow the bracket to fit flush against the wall,
remove molding or mount bracket to the floor. For
wall mount, locate the bracket by placing the back
edge of the template against the rear wall and the
side edge of template on the mark made referen-
cing the side of the range (See Fig. 4). Place brac-
ket on top of template and mark location of the
screw holes in wall. If rear of range is further than
1-1/4" from the wall when installed, attach bracket
to the floor. For floor mount, locate the bracket by
placing back edge of the template where the rear of
the range will be located. Mark the location of the
screw holes, shown in template.
6
Fig. 4
1b. Drill Pilot Holes & Fasten Bracket - Drill
a 1/8" pilot hole where screws are to be located.
If bracket is to be mounted to the wall, drill pilot
hole at an approximate 20° downward angle (See
Fig. 5).
If bracket is to be mounted to masonry or ceramic
floors, drill a 3/16" pilot hole 1-3/4" deep.
The screws provided may be used in wood or
concrete material. Use a 5/16" nut-driver or flat
head screwdriver to secure the bracket in place
(See Fig. 6).
1c. Level and Position Range - Level range by
adjusting the (4) leveling legs with a wrench.
Note: A minimum clearance of 1/8" is required
between the bottom of the range and the leveling
leg to allow room for the bracket. Use a spirit
level to check your adjustments. Slide range back
into position (See Fig. 7). Visually check that rear
leveling leg is inserted into and fully secured by the
Anti-Tip Bracket by removing lower panel or storage
drawer. For models with a Warmer Drawer or broiler
compartment, grasp the top rear edge of the range
and carefully attempt to tilt it forward.
(31.75mm)
Fig. 5
Fig. 7
(31.75mm)
Fig. 6
AA-2282381-1