Sea Eagle Stealth Stalker STS10 Instruction & Owner's Manual page 9

StealthStalker| SETUP: One Time Assembly
StealthStalker| SETUP: Valves & Pump
Swivel Seat/Pedestal
Bolt the seat to the
pedestal using the 1/2"
screws and wing nuts. The
hardware is usually packed
with the seat mount.
Offset the swivel base so
you have enough room
to insert the screws and
thread the nuts. Tighten
the nuts securely.
Caution: Before each
use, check screws that at-
tach swivel seat to the plas-
tic seat and wing nuts that
attach swivel to pedestal.
Loose fasteners could lead
to a fall and injury.
Using the Recessed
Valves:
Remove the cap to access
the valve stem.
Press and turn the stem
counterclockwise so it can
pop UP. When the stem is
up, the valve is closed and
will hold air.
To let air escape for
deflation, press and turn
the stem clockwise until
locked open.
Setup: A41 Large Bellows
Foot Pump
The A41 foot pump comes
with a Recessed Valve
Adapter. A spare adapter is
in the repair kit too.
Adapters have either a red
or black gasket. Black
gasket, which is thinner,
may work better with
STS10.
Using the A41 Large
Bellows Foot Pump:
Open the pump by push-
ing down and releasing the
black clip.
Slide the ribbed end of the
Recessed Valve Adapter to
the open end of the hose.
Screw hose into OUT port
on pump. Make sure it is
threaded in correctly and
firmly for a good seal.
8