Download
Share
Print this page
Sea Eagle 435PS Instruction & Owner's Manual
  1. Manuals
  2. Brands
  3. Sea Eagle Manuals
  4. Boat
  5. PaddleSki 435ps
  6. Instruction & owner's manual

Sea Eagle 435PS Instruction & Owner's Manual

Sea eagle paddleski
Hide thumbs Also See for 435PS:

Advertisement

Quick Links

Download this manual
Sea Eagle PaddleSki
435PS
VIDEO
INSTRUCTIONS
Instruction & Owner's Manual
For video instructions visit SeaEagle.com/Instructions
Sea Eagle Boats Inc.
19 N. Columbia Street, Suite 1
scan this code
Port Jefferson, NY 11777
or visit
1-800-748-8066
http://sea.gl/vips
September 2012

Advertisement

loading

Related Manuals for Sea Eagle 435PS

Summary of Contents for Sea Eagle 435PS

  • Page 1 Sea Eagle PaddleSki 435PS VIDEO INSTRUCTIONS Instruction & Owner’s Manual For video instructions visit SeaEagle.com/Instructions Sea Eagle Boats Inc. 19 N. Columbia Street, Suite 1 scan this code Port Jefferson, NY 11777 or visit 1-800-748-8066 http://sea.gl/vips September 2012...
  • Page 2 Sea Eagle must inspect equipment in order to determine if there is a defect. In the event that an item must be shipped back to us for inspection, Sea Eagle will only reimburse the standard return shipping charge through FedEx, UPS or the U.S.
  • Page 3 Under no circumstance should you equip a motor that exceeds these capacities (whether they be for the dry weight or the horsepower or both). Not only can this result in damaging your Sea Eagle Frameless Pontoon Boat, it will also void your Sea Eagle warranty.
  • Page 4 • DO NOT use compressors, co2 or compressed air for inflation, only use Sea Eagle recommended pumps. • DO NOT use your Sea Eagle Boat as a personal flotation device as they are designed for leisure/recreation in mind. • DO NOT sleep inside of your Sea Eagle while on the water.
  • Page 5 1 is the only two halves of the foot adapter needed for your pump together and con- Sea Eagle. nect the hose to the in- flation port marked OUT. Insert the valve adapter at the other end of the hose.
  • Page 6 3.2 PSI which is battery, plug it into the the operating pressure charger and then plug of your Sea Eagle. PSI the charger into a is marked in red on the household electrical dial. Never turn the dial outlet.

  • Page 7: Assembly & Inflation

    Locate a relatively clean Attach the seat clips on to the D-Rings on your space to unpack your Sea Eagle. Adjust the Sea Eagle. Inflate both straps on the seat for of the pontoons and comfort. If you’re solo...
  • Page 8 4-Part Paddle Fishing Swivel Kit Each paddle includes (OPTIONAL) two shafts, two blades Includes swivel seat, and 2 drip guards. seat mount, aluminum Its important to follow platform, aluminum the directions exactly as crossbar yokes, 2 rod assembling the paddles holders and hardware incorrectly may leave for assembly.
  • Page 9 Attach the rod holders Begin assembly of the through the flush rowing frame by laying mounts at each end of the 2 aluminum bars the long yoke. parallel to one another and attach the rowing arm at one end (using the 1 ½”...
  • Page 10 These motors run off a 12v deep cycle marine battery (which is not included or sold by Sea Eagle). Use the enclosed straps Portable Charger to secure the motor (OPTIONAL) mount board. Run the...
  • Page 11 Built-in battery meter includes If you’re planning to leave your Sea Eagle outside, be sure two 12-volt accessory to keep it raised up off of the ground. Its also a good idea to...

  • Page 12: Troubleshooting

    Repairs Place the boat at the center of the opened Although our Sea Eagles are very rugged and tough, you boat bag and wrap the may still experience the occasional puncture through use of boat with the narrow your boat. Fortunately most repairs are fairly easy and only flaps first.
  • Page 13 For immediate use Place the patch on the allow 30 minutes to dry damaged area and and then inflate the press down firmly. Let compartment with the the glue sit for 2-4 min- repair only 3/4 full and utes until it appears be sure to make a more tacky.
  • Page 14 MEK is very flammable, Inflate the chamber to keep away from fire, lit full pressure if possible cigarettes or sparks. and loosen with the When handling MEK valve wrench by turning we recommend wear- it counterclockwise. ing rubber gloves. Be Deflate the chamber sure to use MEK in a and unscrew the valve...