Sea Eagle Stealth Stalker STS10 Instruction & Owner's Manual page 8

Table of Contents

Advertisement

StealthStalker|
SETUP: One Time Assembly
There are some items that require one time assembly. Once
installed they may remain in place when the boat is rolled up
after use or require partial assembly for use.
**Not all items described below are included with all boat
packages.
Attach Seat Mounts to
Floorboards
Non-skid textured surface
faces upward in boat. Seat
release attaches to rough
surface.
Needed: #2 (medium) or #3
phillips head
screwdriver.
Seat Mounts
Each floor board has holes
for a quick-release seat
mount.
Hardware per seat mount:
4 - 1-1/4" flathead screws
4 - T-nuts
Insert screws through holes
in seat mount.
With rough side facing up,
point mount tab towards
long edge of floorboard and
place mount over screw holes.
Stand floorboard up on its
edge so it is easier to work on.
On the bottom side of board,
begin turning T-nuts onto the
screws.
Note: If holes are partially
covered by filler or paint, clear
holes with screwdriver, file or
similar tool.
Hold T-nuts with finger tip.
Use screwdriver to tighten
screws.
Rod Holder
Base
Release
Button
Anchor
Lock Base
STS10 is equipped with
Scotty Glue-on pads: one
bow, one stern. These are
primarily intended for
Scotty Anchor Lock, but
can be used for Scotty rod
holders, triple mounts, fish
finder display, transducer,
cameras, bait boards, etc.
Scotty® Deck Mounts
(OPTIONAL):
Locate the Scotty Deck
Mounts and 7/8" screws.
Screws are located in the
Orange Repair Kit.
Note: The Rod Holder Base
has a quick release button.
The Anchor Lock Base uses
a twist lock system.
Operation see page 9.
Use the screws to secure
the mounting base to the
pad. Orient the base so
arrow points inboard.
Caution: Puncture
hazard: do not thread
screws into base without
the Scotty Deck Mount.
Don't Stab The Pad!
Use only ¼ - 20 x 7/8"
screws provided in the
orange repair kit. Longer
screws, pointed screws,
etc., will puncture the air
chamber.
Puncturing the air chamber
in this manner is not covered
under the warranty.
7

Advertisement

Table of Contents
loading

Table of Contents