Related Manuals for Sea Eagle PaddleSki 395ps
Summary of Contents for Sea Eagle PaddleSki 395ps
- Page 1 PaddleSki Instructions and Owner’s Manual PaddleSki 395ps - PaddleSki 435ps July 2007 19 N. Columbia St., Suite 1, Port Jefferson, NY 11777 (631) 473 7308...
- Page 2 Pipe Valve: For old Deluxe Kayak The yokes are bolted from Seats and Deluxe Fly Fishing Seats below and fastened with a Sea Eagle pipe valves are simple, knurled nut as shown above. reliable and compact. Insert the They need not be extremely...
- Page 3 To close, tightly pinch the pipe At this stage the foot pump will section of the valve with your become extremely hard and you forefinger and thumb while you will not be able to press it any remove the pump nozzle from the further.
- Page 4 Recessed One-Way Valve on the boat and .75 psi. The PaddleSki 395ps and 435ps are made from our switch on the pump. The pump will go through the two stage reinforced 1000 denier hull material, which inflates to 3.2 PSI.
- Page 5 Rowing Frame Installation of Rowing Frame & Sliding Seat for PaddleSki Parts: (1) Predrilled Plastic board for Rowing Frame (2) Sliding Seat with cushion (not shown) (3) Rowing Arm (4) Pre-drilled Plastic Strip (5) 2 Predrilled Aluminum bars The above pre-assembled frame can be used for Rowing Frame or Sliding Seat configurations as below: A) Rowing Frame Configuration Place the predrilled plastic board on the assembled frame as...
- Page 6 (a) and 4 large washers (b) as shown below. Attach the sliding seat cushion to the the sliding board for comfort during rowing. The motormount for the Sea Eagle PaddleSki contains the following parts shown above: 1 Motormount Yoke Board, 1 Motormount upright board, 4 Bolts 2 L Brackets and 2 Straps.
- Page 7 Use one of the enclosed straps secure The lifespan of your new Sea Eagle motormount yoke board. Run boat can be extended by using 303 the strap only through the Protectant.
-
Page 8: Troubleshooting
Troubleshooting First locate the leak by the methods above. Soapy water will bubble out from the Leakage of air: If your boat appears a bit soft, it might not be source of the leak. because of a leak. If the boat was inflated late in the day with 90 degree air, that air might cool 20 degrees overnight. - Page 9 Deflation and Rollup 19 N. Columbia St. If you plan on storing your PaddleSki for Port Jefferson, NY 11777 more than a few days, it is best to towel it Phone # : (631) 473 7308 Fax # : (631) 473 7398 off or let the boat dry staff@SeaEagle.com in the sun to remove...