Sea Eagle Stealth Stalker STS10 Instruction & Owner's Manual page 13

StealthStalker | ASSEMBLY & INFLATION
For ease of installation, lift
canopy up off the back of
the boat so the side rods
line up with the grommet
holes. Insert 35mm screw
through the grommet and
rod. Use knob to secure the
screw. Repeat on the other
side.
Insert 35mm screw through
the grommet and rod. Use
knob to secure the screw.
Repeat on the other side.
A Phillips head screw driver
may be needed for this
step.
Attach front straps to
D-Rings near front seat.
Attach back straps to
D-Rings at the back of the
boat.
Adjust and tighten staps by
sliding the buckles. Canopy
canvas should be level and
tight.
Your Sea Eagle Stealth Stalker is ready to go!
Pro Solo
WaterSnake
Motor Canopy
Floor Drains
Floor drains are intended
to drain accumulatedwater
while ashore.
Unscrew caps to open floor
drains. If needed, remove
cap from its retainer ring so
water drains freely without
interference from cap.
If drains leak, refer to
Troubleshooting page 16.
12