Sea Eagle Stealth Stalker STS10 Instruction & Owner's Manual page 11

StealthStalker | ASSEMBLY & INFLATION
While the boat is deflated
or partially inflated, slide
motor lower mount bars
into lower grommets.
Slide upper motor mount
bars into top grommets.
Push bars onto the
grommets until they are
fully seated.
Inflation
Close the valves. Twist the
valve stem clockwise and
allow the stem to pop up.
This will close the valve for
inflation.
Insert the valve adapter
into the valve and turn it to
lock the hose in place.
Having trouble inserting the
adapter? See troubleshoot-
ing on page 14.
Inflate each chamber until
it is very firm. You cannot
over inflate with the Sea
Eagle A41 foot pump.
Swivel Seat
Slide the base of the
pedestal into the seat
mount until you hear it
lock. To remove, lift the tab
and slide out.
Caution: Check
wingnuts and tighten if
necessary before each use.
Quick Release Base:
Push stem into base until
it clicks. To rotate or re-
move rod holder, press
button and pull rod holder
upwards. To adjust rod
angle, loosen large black
knob until teeth clear
Release Release
groves. Adjust angle and
retighten.
Button Button
Anchor Lock Base:
Line up the slot in the
stem with key in the base.
Slide stem into base.
To spin the Anchor Lock,
lift slightly and turn it. To
remove it, turn it until the
key and slot line up and
pull it out.
Turn Anchor Lock so
anchor hangs overboard.
An 8-12 lb. mushroom or
river anchor works well
with the STS-10.
10