Table of Contents
Advertisement
StealthStalker |
ASSEMBLY & INFLATION
Stow Bag
Insert the male clip into the
female part installed on the
boat.
Oars
The pair of two-part oars
snap together quickly.
Caution: Pinching
Hazard. Keep skin clear of
joint when pushing oar
shafts together.
Hold the pin down and
insert the blade end into
the handle end of the oar
until the two parts snap
together and the pin pops
out of the hole locking the
pieces together.
Attach oars to boat by
inserting the oar lock pin
through the hole in the oar.
Screw the ball tightly to
secure oar.
Use the hook & loop
closure to keep the oar in
place when not in use.
Canopy (OPTIONAL)
Canopy kit includes two
curved bars, two side rods,
canvas, two black knobs
and two 35mm (1 3/8")
screws.
Additional hardware may
be included that is not for
use on the STS10.
Layout canvas upside
down (shiny side up).
Slide one curved bar into
the canvas sleeve with
locking holes up.
Slide the second bar into
the other sleeve with
locking holes facing down.
Fold the top over so side
bars are lying on top of
each other.
Insert the side rods into the
curved bars until the
locking pins engage
through the holes.
Place canopy on the back
of the boat with the short
bars on top.
11
Advertisement
Table of Contents
