Kongsberg Simrad SU90 Manual page 60

Simrad SU90 Harbour Acceptance Test
To set up the Ethernet communication, you must define the IP address for the panel, and
identify the Processor Unit in the panel software. These settings allow you to use more
than one Operating Panel on the Processor Unit. You can also control more than one
Processor Unit from a single Operating Panel.
The IP and MAC addresses for your Processor Unit are contained in a text file named
IPandMACaddress.txt
in the following format (example):
SU90
157.237.60.14
AC:1F:6B:1D:42:E6
If the text file is missing you must find the information manually. We suggest that you do
this, and create the necessary folder and txt file before you start the setup process. See
step 1 in the procedure.
Note
If the Operating Panel fails to establish contact with the Processor Unit it will time
out and switch itself off after two minutes. When this happens the blue indicator light
stops flashing.
Procedure
If required, locate the IP and MAC addresses on the ETH1 Ethernet adapter in the
Processor Unit.
1 Obtain the IP address.
The IP and MAC addresses for your Processor Unit are contained in a text file
named
IPandMACaddress.txt
information manually.
a In the bottom-left corner of your desktop, select the Windows
b On the menu, select
c Observe that the
d Select
Network & Internet
e Select
Change adapter options
f Select the relevant network adapter, then right-click and select
the short-cut menu.
g On the list of connections, select
.
Properties
h Observe the IP address for the Ethernet adapter.
i Write down the information.
j Close all the dialog boxes.
Obtain the MAC address.
60
. The file contains the product name, IP address and MAC address
. If the text file is missing you must find the
.
Settings
Windows Settings
.
.
dialog box opens.
Internet Protocol 4 (TCP/IPv4)
® button.
Start
on
Properties
, and then
409977/C