Kongsberg Simrad SU90 Manual page 44

Simrad SU90 Harbour Acceptance Test
Context
Note
The speed input is essential for SU90 operation. Without speed information, the SU90
system will neither be able to present correct navigational information, nor compensate
for vessel movements. This lack of compensation will prevent the system from providing
correct echo information. If you do not use a dedicated speed log, but rather a GPS
system, you can skip this test.
In most cases a suitable sensor is already installed on the vessel. A global positioning
system (GPS) with a compatible output format can also be used.
The properties of each of the available communication ports are defined on the
page. The
Setup Sensor Installation
with external sensors and systems. To make sure that the information from the "most
reliable" sensors are used by the SU90 system, use the
define a datagram priorities.
The communication parameters defined for NMEA 0183 are:
• : 4800 bit/s
Baud rate
• : 8
Data bits
• : Even
Parity
• : 1
Stop bits
Some instruments may provide other parameters and/or options. You must always check
the relevant technical documentation supplied by the manufacturer.
Procedure
1 Open the
Setup
2 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
3 On the left side of the
a Select the relevant sensor in the
b Make sure that the correct installation parameters are used for the sensor.
4 On the left side of the
a Select the relevant sensor in the
b Make sure that the correct parameters are used for sensor configuration.
5 Close the
Installation
6 Observe the top bar.
44
page allows your SU90 system to communicate
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
dialog box, select
Installation
dialog box without making any changes.
Sensor Configuration
.
Sensor Installation
list.
Installed Sensors
Sensor Configuration
list.
Sensor
I/O
page to
.
.
409977/C