Kongsberg Simrad SU90 Manual page 42

Simrad SU90 Harbour Acceptance Test
reliable" sensors are used by the SU90 system, use the
define a datagram priorities.
The communication parameters defined for NMEA 0183 are:
• : 4800 bit/s
Baud rate
• : 8
Data bits
• : Even
Parity
• : 1
Stop bits
Some instruments may provide other parameters and/or options. You must always check
the relevant technical documentation supplied by the manufacturer.
Procedure
1 Open the
Setup
2 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
3 On the left side of the
a Select the relevant sensor in the
b Make sure that the correct installation parameters are used for the sensor.
4 On the left side of the
a Select the relevant sensor in the
b Make sure that the correct parameters are used for sensor configuration.
5 Close the
Installation
6 Observe the top bar.
7 Make sure that the information from the sensor is displayed.
If necessary, enable the read-out in the
8 If possible, use another instrument to verify that the information provided by the
SU90 is correct.
9 Fill in the result tables.
Result
Sensor Source sensor
Position
Speed
Distance
Heading
42
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
dialog box, select
Installation
dialog box without making any changes.
Datagram
Sensor Configuration
.
Sensor Installation
list.
Installed Sensors
Sensor Configuration
list.
Sensor
dialog box.
Display Options
Port
page to
.
.
Baud rate
409977/C