Kongsberg Simrad SU90 Manual page 46

Simrad SU90 Harbour Acceptance Test
Context
Note
The input from a course gyro is essential for operation. Without the input from a course
gyro, the SU90 system will not be able to present correct navigational information.This
lack of compensation will prevent the system from providing correct echo information.
In most cases a suitable course gyro is already installed on the vessel. A global
positioning system (GPS) with a compatible output format can also be used.
The properties of each of the available communication ports are defined on the
page. The
Setup Sensor Installation
with external sensors and systems. To make sure that the information from the "most
reliable" sensors are used by the SU90 system, use the
define a datagram priorities.
The communication parameters defined for NMEA 0183 are:
• : 4800 bit/s
Baud rate
• : 8
Data bits
• : Even
Parity
• : 1
Stop bits
Some instruments may provide other parameters and/or options. You must always check
the relevant technical documentation supplied by the manufacturer.
Procedure
1 Open the
Setup
2 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
3 On the left side of the
a Select the relevant sensor in the
b Make sure that the correct installation parameters are used for the sensor.
4 On the left side of the
a Select the relevant sensor in the
b Make sure that the correct parameters are used for sensor configuration.
5 Close the
Installation
6 Observe the top bar.
7 Make sure that the information from the sensor is displayed.
46
page allows your SU90 system to communicate
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
dialog box, select
Installation
dialog box without making any changes.
Sensor Configuration
.
Sensor Installation
list.
Installed Sensors
Sensor Configuration
list.
Sensor
I/O
page to
.
.
409977/C