Lamp Replacement; Cleaning And Maintenance - TESY CH20060IX Instructions For Use And Maintenance Manual

Description of the control buttons shown in figure 5:
EN
– Button for switching off the ventilation
I – 1st ventilation speed
II – 2nd ventilation speed
III – 3rd ventilation speed
– Button for switching on/off the lightening
This model allows you to set the range hood to operate
at a ventilation speed which you wish, for example
speed III, and you can switch directly to speed I or go
back to speed III or the other way round.
OPERATING THE RANGE HOOD WITH AND
WITHOUT ACTIVE CARBON
Do not use the appliance without filters!
TESY range hoods are intended for use with standard
aluminium filters and also with filters with carbon which
may be purchased separately.
If there is not a chimney in the room the range hood
shall be used with a carbon filter to clean the air.
This filter is not included in the package, but you can
purchase it from Your supplier or service centre. In
this manner of operation the filter shall be replaced
with a new one every 3 to 5 months depending on the
frequency of use.
Never wash the carbon filter. Keep it away from
children.
Before replacing the carbon filter You must switch
off the power supply of the range hood by
unplugging the power cord from the socket or by
switching off the circuit breaker.
Carbon filters come in a pair (left and right one) and you
need to observe their direction during installation.
Figure 6 – Installation method for carbon filters
6
Instructions for use and maintenance

LAMP REPLACEMENT

Before replacing the lamp You must disconnect
the appliance from the mains. Let the lamp cool
down, otherwise You may burn yourself.
•
Remove the aluminium filters.
•
Unscrew the faulty lamp in counter clockwise
direction.
•
Screw the new lamp in clockwise direction.
•
Reinstall the aluminium filters.
Figure 5 – E14 holder and 3W LED lamp

CLEANING AND MAINTENANCE

Cleaning and maintenance of this appliance shall
not be done by children!
The surface may got damaged if any sharp or
abrasive cleaning objects or detergents are used.
Never use such. You can obtain suitable cleaning and
protective detergents from your dealer. The surface of
the appliance and the control elements are sensitive to
scratches.
Clean the surface with a soft damp cloth, detergent
for dishwashers or soft glass detergent. Do not use dry
towels, abrasive sponges, substances which require
rubbing, detergents which contain sand, soda, acid or
chlorine or other strong chemicals.
Clean the inox surfaces only in the direction of rubbing.
Do not use detergents and wet towels on the control
elements.
Wait until the appliance has cooled down before
cleaning it. Disconnect it from the power socket
or the circuit breaker.
There is risk of damage caused by moisture penetrating
into the electronic components. Never clean the control
elements with damp cloth.