Advertisement
WARNINGS, TIPS, & REQUIRED TOOLS
Curtis cabs feature an assembly of parts designed for your vehicle which require adjustment
and alignment of components to accommodate vehicle variations and provide proper weather
protection. For accurate installation, proper operation, and years of satisfaction, please read
and understand the installation and owner's manual fully prior to installing the cab.
From all of us at Curtis, we thank you for choosing our product
ADDED
WEIGHT
Curtis Cabs, blades and general accessories
add additional weight to the base vehicle. All
Curtis accessory weights are listed in product
brochures. Deduct the accessory's total weight
from the vehicle's rated capacity and never
exceed the vehicle's rated capacity including
driver and passenger.
Exposure to Carbon Monoxide
can Cause illness, serious injury or
death.
Never operate vehicle if suspicious of Carbon Monox-
ide. Inspect exhaust system for leaks monthly. Leaks can
result from loose connections, corrosion, cracks or other
damage to the exhaust manifold. If leaks are found, repair or
replace exhaust system. Do not use vehicle until repair or
replacement is complete.
California Health and Safety Proposition 65 Warning: This product may contain chemi-
cals known to the state of California to cause cancer and birth defects or other reproductive harm.
GENERAL INFORMATION BEFORE YOU START
HELPFUL HINTS:
•
Refer to parts diagram found in the service parts section of this manual to help identify parts during the assembly process.
•
To assist with the cab installation, leave all fasteners loose for later adjustment unless otherwise specified.
•
Read and understand all instructions before beginning.
•
Apply a silicone sealant to seal any minor gaps that may occur due to vehicle variations.
•
Use caution to avoid damaging the factory installed threaded inserts or weld nuts. Begin the thread engagement by hand to
avoid or correct potential cross threading.
•
Make sure the areas where the supplied self-adhesive hook Velcro and seals will be applied are clean, dry, and at room
temperature for best adhesion.
•
Before installing parts with factory installed rubber, make sure the rubber is fully installed onto the parts for proper fit and
sealing.
TOOLS REQUIRED:
•
Set of Standard and Metric Sockets (3/8" Drive)
•
3/8" Drive Ratchet with Extension
•
Torque Wrench
•
Set of Standard and Metric Open-End Wrenches
•
Set of Standard and Metric Allen Wrenches
•
#2 and #3 Phillips Head Screwdrivers
•
Flat Head Screw Driver
•
Body Clip Removal Tool
•
Pliers
•
Non-Marring Pick
•
(2) Quick Grip Clamps
•
Bar clamp (optional)
•
5/16" Nut Driver
•
Coolant Drain Pan
.
•
Drill/Driver
•
#2 and #3 Phillips Head Bit
•
Utility Knife
•
Pair of Scissors
•
Shears
•
Grease
•
Silicone Sealant
•
Teflon Tape
•
Tape Measure
•
China Marker or other Non-Permanent Marker
•
Snips
3 of 28
Advertisement
