Advertisement
STEP 7: (SIDE FRAMES CONT'D)
7.3
Fasten the side frame to the cowl as shown in Fig-
ure 7.3.
Hardware Used
5/16-18 X 3/4 Hex Head Screw
5/16-18 Hex Nut
Tools required
1/2" Wrench and Socket
7.4
Repeat steps 7.1 thru 7.3 on the right side of the
vehicle.
STEP 8: (WINDSHIELD SUPPORT)
8.1
With assistance, align sides and top of the windshield
support with the side frames. Fasten the windshield
support in place with a screw through the front of each
side frame. See Figure 8.1. Confirm bolt holes in the top
of the windshield support align with the inserts in the
side frames and tighten hardware.
Hardware Used
5/16-18 X 3/4 Hex Head Screw
Tools required
1/2" Wrench or Socket
STEP 9: (LOWER REAR PANEL)
9.1
Fasten the lower rear panel to the rear legs as shown in
Figure 9.1.
Hardware Used
1/4-20 X 5/8 Hex Head Screw
1/4-20 Flange Hex Nut
Tools required
3/8" Wrench and Socket
7/16" Wrench and Socket
Note: On backhoe equipped vehicles, the lower rear panel
will need to be removed to operate the backhoe. It is up
to the discretion of the operator whether or not to
reinstall.
CAB INSTALLATION
Qty
2
2
Qty
2
Qty
4
4
5/16-18 Nuts
Fig. 7.3 (Side Frame to Cowl Fasteners)
5/16-18 x 3/4 Screws
Fig. 8.1 (Windshield Support to Side Frame Fasteners)
1/4-20 Nut
1/4-20 x 5/8 Screws
Fig. 9.1 (Lower Rear Panel)
9 of 28
5/16-18 x 3/4 Screws
Advertisement
