Advertisement
CAB FEATURES & OPERATION
BACKHOE OPERATION
On backhoe equipped vehicles, the lower rear panel will need
to be removed to operate the backhoe. Remove the Rear
Window First. Then remove mounting hardware from Lower
Rear Panel and store in a plastic bag.
Store the lower rear panel in a safe location to prevent
damage.
Tools required
3/8" Wrench or Socket
7/16" Wrench or Socket
REMOVABLE RADIATOR SHROUD
PANEL
Your Workmaster 25S series cab comes equipped with a
removable metal panel for extra air flow on hot summer days.
Should your temperature gauge climb on a hot day, follow this
procedure:
1. Make sure you provide ventilation to the cab by
venting windshield, venting or removing rear
window, or removing doors.
2. Remove the metal panel to allow additional air
flow to the radiator.
Remove mounting hardware and store in a plastic bag.
Store the metal panel in a safe location to prevent damage.
Warning!
Never remove the panel without ventilating
the cab. This may cause Carbon Monoxide to be drawn into
the cab. Carbon Monoxide can cause illness, serious injury,
or death.
REMOVABLE RADIATOR SHROUD
The radiator shroud can be removed if required for sercice.
Below are the steps to do so:
1.
Remove heater from heater bracket and let hang from
hoses. (see step 16.2).
2.
Disconnect heater hoses at quick disconnects, see figure
17.3.
3.
Remove thumbs nuts and slide shroud backwards. See
steps 4.3 and 7.2.
CAB INSTALLATION
Removable Lower Rear Panel
Removable Shroud Panel
JUMP STARTING TRACTOR
How to jump start the tractor with Cab installed:
1.
Connect red jumper to heavy gauge wire terminal on
starter.
2.
Connect black to frame bolt – ground.
20 of 28
Advertisement
