Advertisement
STEP 20: (SMV SIGN)
20.1 Re-install SMV Sign and Bracket removed on step 1.3
using the supplied 40mm long spacers (ref.: 1.57" long)
per figure 20.1.
Hardware Used
M8X1.25 X 60mm Hex Screw
M8 X 40mm long spacer
Tools required
13mm Wrench and Socket
STEP 21: (Tool Box Relocation)
21.1 Remove factory tool box from factory mounting bracket.
Tools required
13mm Wrench or Socket
21.2 Secure the supplied tool box relocation bracket to the
ROPS with the hardware that was removed during step
1.2. See Figure 21.2. Note: can be installed on the left
or right side of ROPS depending on desired access on
backhoe (if installed).
Tools required
12mm Wrench or Socket
21.3 Fasten the factory tool box to the previously installed
relocation bracket as shown in Figure 21.3.
Hardware Used
5/16-18 x 3/4" Hex Head Screw
5/16-18 Hex Nut
Tools required
1/2" Wrench and Socket
CAB INSTALLATION
Qty
2
2
Qty
2
2
Spacers Here
Fig. 20.1 (Relocated SMV Sign and Bracket)
Fig. 21.2 (Tool Box Offset Bracket, Left side of ROPS)
Fig. 21.3 (Install Tool Box onto Offset Bracket)
16 of 28
Advertisement
