Advertisement
STEP 5: (REAR LEGS)
5.1
Fasten the rear leg to the previously installed ROPS
brackets. See Figure 5.1.
Hardware Used
5/16-18 X 3/4 Hex Head Screw
5/16-18 Hex Lock Nut
Tools required
1/2" Wrench and Socket
5.2
Repeat step 5.1 on the right side of vehicle.
STEP 6: (LOWER FRONT MOUNTS)
6.1
Install left side lower front mount using supplied
hardware listed below. See Figure 6.1. Note: If
backhoe or No-Loader Adapter Kit is installed, 1/2"
spacers are not required.
Hardware Used
M12x1.75 X 55 Hex Head Screw
M12 Washer
M12x1.75 Flange Hex Nut
1/2" ID X 3/4" OD X 1/2" THK Spacer
Tools required
19mm Wrench and Socket
6.2
Repeat step 6.1 on the right side of vehicle.
STEP 7: (SIDE FRAMES)
7.1
With assistance, remove the pre-assembled left door
from the left side frame and set aside. Do not lose the
brass washers on the hinge pins.
7.2
Fasten the left side frame to the left Front Mount,
Radiator Shroud, and Rear Leg. See Figures 7.2a and
7.2b.
Hardware Used
5/16-18 X 3/4 Hex Head Screw
5/16-18 X 1 Button Head Screw
5/16-18 Flat Washer
5/16-18 Hex Nut
1/4-20 Thumb Nut
Tools Required
1/2" Wrench or Socket
3/16" Allen Wrench
CAB INSTALLATION
Qty
2
2
Qty
2
2
2
2
Qty
5
2
2
2
1
5/16-18 Nuts
5/16-18 x 3/4 Screws
Fig. 5.1 (Rear Leg to Side Frame Fasteners)
Spacer Behind Lower
M12 Washer
Fig. 6.1 (Lower Front Mount, Left)
Fig. 7.2a (Side Frame)
1/4-20
Thumb
Nuts
5/16-18
Nuts
Fig. 7.2b (Side Frame, Detail View)
8 of 28
Front Mount
Lower Front Mount
5/16-18 x
3/4 Screws
5/16-18 Button
Head Screws
5/16 Washers
Advertisement
