Advertisement
STEP 2: (REAR MOUNT BRACKETS)
2.1
Using the fasteners listed below and those that were
removed during step 1.4, first install the spacers and
then the rear mount bracket on the left side of vehicle
with the small flange facing up. See Figure 2.1.
Hardware Used
1/2" ID X 3/4" OD X 5/32" THK Spacer
Tools required
17mm Wrench or Socket
2.2
Install lower left mount per Figure 2.2.
Hardware Used
5/16-18 X 3/4 Hex Head Screw
5/16-18 Hex Nut
Tools required
1/2" Wrench and Socket
2.3
Install left tail light on rear mount bracket, removed
during step 1.5. See Figure 2.3.
Tools required
17mm Wrench
2.4
Repeat steps 2.1 thru 2.3 on the right side of the
vehicle.
STEP 3: (ROPS BRACKETS AND
CLAMPS)
3.1
Measure down from the tab found on the ROPS
Structure approximately 7/8". Make a mark using a
china marker or other non-permanent marker. Install the
left ROPS bracket and clamp. See Figure 3.1.
Hardware Used
5/16-18 X 3/4 Hex Head Screw
5/16-18 Hex Nut
Tools required
1/2" Wrench and Socket
3.2
Repeat step 3.1 on the right side of the vehicle.
CAB INSTALLATION
Qty
2
Qty
2
2
Qty
4
4
Fig. 2.1 (Rear Mount Bracket Orientation)
Fig. 2.2 (Lower Rear Mount Orientation)
Note: Red on back
lower half of tail light.
Fig. 2.3 (Re-Install Tail Light)
Fig. 3.1 (ROPS Bracket and clamp, left)
6 of 28
ROPS Tab
7/8"
Advertisement
