Advertisement
STEP 15: (REAR WINDOW)
15.1 Grease the hinge pins found on the left side rear leg
and slide on greased brass washers (one washer per
pin). See Figure 15.1.
15.2 Hang the rear window on the hinges.
Note: Loosen rear window hinges if adjustment is needed.
15.3 Connect the window latches to the right rear leg by
depressing the tabs on the latch and inserting into the
receivers mounted on the rear leg. Close and check the
alignment of the window. If off, check measurements
and re-align the rear legs. Tighten the hinge hardware
to 7 ft.-lbs. Verify smooth operation of the latches.
STEP 16: (HEATER)
16.1 Attach the heater bracket to the left side frame. See
Figure 16.1. Fully tighten hardware at this time.
Hardware Used
5/16-18 x 3/4" Hex Head Screw
Tools required
½" Socket with Extension
16.2 Attach the heater to the heater bracket by removing and
re-using the screws on the side of the heater. Tighten
hardware.
Tools needed
#2 Phillips Screw driver.
STEP 17: (HEATER PLUMBING)
* CAUTION * To avoid injury caused by hot engine
coolant, make sure the engine has completely cooled
down before beginning plumbing of auxiliary heater.
17.1 Place a clean coolant drain pan under the radiator.
Next, drain coolant from radiator petcock. See fig. 17.1.
17.2 Snap provided ¾" bushings into the plastic radiator
shroud from the inside. Cut (2) 17" pieces of the
provided 5/8" diameter heater hose. Slide (2) 1" hose
clamps on the end of the (2) cut hoses. Slide the hoses
onto the end of the (2) heater nipples and tighten down
the hose clamps. Next, slide the (2) hoses through the
snap bushings. Make sure not to kink the hose. See
Figure 17.2.
CAB INSTALLATION
Qty
2
Brass Washers
on Greased Pins
Fig. 15.1 (Hang Rear Window)
5/16-18 x 3/4" Screws
Fig. 16.1 (Install Heater Bracket to Side Frame)
Fig. 17.1 (Petcock Valve Under Radiator, Right Side)
Snap Bushings
Fig. 17.2 (Heater Hose Routing)
13 of 28
Snap Latches
into Right
Rear Leg,
2 Places
Petcock
Drain Hose
1" Hose
Clamp
Advertisement
