Advertisement
STEP 4: (RADIATOR SHROUD, LOAD
LOCK LEVER & COWL)
4.1
Position the radiator shroud on the vehicle just in front
of the front lip of the floorboard per figure 4.1. Install Tip:
If needed, move the rubber boot of the jockstick out of
the way when placing the shroud in place. Place the
boot back in place once shroud is placed.
4.2
Install Thumb Screw into previously installed Load Lock
Lever Extension bracket (Step 1.10). Make sure there
is enough thread on the inside for a hex nut to fit. Then
thread and tighten on the hex nut on the inside. See
Figures 4.2a and 4.2b.
Hardware Used
Thumb Screw, 3 inches long
#10-32 Hex Nut
Tools required
3/8" Wrench or Socket
4.3
Install steel cowl in front of radiator shroud per figure
4.3a. For best seal, make sure that rubber running
across the top of the dashboard (between the white
arrows) is pushed back and pushed forward as it runs
down the side of the dash (outside the white arrows) as
shown in figure 4.3b.
Hardware Used
1/4-20 Thumb Nut
Push rubber back towards
steering wheel between
the white arrows.
Fig. 4.3b (Cowl Rubber)
CAB INSTALLATION
Qty
1
1
Qty
5
Fig. 4.1 (Radiator Shroud, Right)
Figure 4.2a (Load Lock Lever, Cab inside)
Figure 4.2b (Load Lock Lever, Cab outside)
Fig. 4.3a (Cowl)
7 of 28
Boot
Lip of floorboard
#10-32 Hex Nut
Advertisement
