Design Concept; Helpful Reminders; Tools Required - Curtis JOHN DEERE 4500 Installation & Owner's Manual

DESIGN CONCEPT

Curtis Cabs feature an assembly of parts designed for your vehicle which require
adjustment and alignment of components to accommodate vehicle variations and
provide proper weather protection. For accurate installation, proper operation, and
years of satisfaction, please read and understand the installation instructions.
From all of us at Curtis, we thank you for choosing our product.
ADDED
WEIGHT
Curtis Cabs, blades and general accessories
add additional weight to the base vehicle. All
Curtis accessory weights are listed in product
brochures. Deduct the accessories total weight
from the vehicles rated capacity and never
exceed the vehicles rated capacity including
driver and passenger.
CAB INSTALLATION
BEFORE YOU START

HELPFUL REMINDERS:

A. Leave all bolts loose for later adjustment unless otherwise specified.
B. Read and understand all instructions before beginning.
C. Plastic washers have been supplied to provide a weather seal around
all exterior fasteners. The plastic washer should be installed under each
bolt head directly against the outside cab surface. Care should be taken
not to over tighten the fasteners and damage the plastic washer.
Also use metal washers as required.
D. Apply a clear silicone sealant to seal any minor gaps that may occur due
to vehicle variances. For example, windshield cowl to unitized frames.

TOOLS REQUIRED:

7/16 IN.
3/8 DRIVE
SOCKET
1/2 IN.
3/8 DRIVE
NO. 2 MEDIUM
DEEP
PHILLIPS HEAD
SOCKET
SCREWDRIVER
This Curtis Cab is designed and manu-
factured for use only as reasonable
weather protection. This cab is not applicable, nor should
the cab be considered as protection against roll over,
collision or other accidents that may result. This cabs is
NOT a R.O.P.S. cab. Extreme care should be taken when
operating and by qualified, experienced operators only
3/8 IN.
DRILL BIT
3/16 INCH
10MM
ALLEN
3/8 DRIVE
DRIVE
SOCKET
3/8 DRIVE
Never operate vehicle if suspicious of Carbon Monoxide.
Inspect exhaust system for leaks monthly. Leaks can result
from loose connections, corrosion, cracks or other damage
to the exhaust manifold. If leaks are found, repair or replace
exhaust system. Do not use vehicle until repair or replace-
.
ment is complete.
3/8 IN.
ELECTRIC
HAND DRILL
Exposure to Carbon Monoxide can
Cause illness, serious injury or death.
7/16", 1/2", 7/8", and 1"
OPEN END WRENCHES
3/8" DRIVE
RATCHET
p. 2 of 11