Advertisement
STEP 11: (WINDSHIELD)
11.1 With assistance, set the windshield up to the side
frames and secure it to the windshield support using the
hinge spacers and hardware. See Figure 11.1. Leave
hardware loose.
Hardware Used
5/16-18 x 1.5" Flat Head Screw
5/16-18 Hex Lock Nut
Tools required
#3 Phillips screw driver
½" Wrench or Socket.
11.2 Secure the windshield latches to the side frames with
the latches open, and tighten latch hardware. See
Figure 11.2.
Hardware Used
¼-20 x 5/8" Hex Head Screw
¼-20 Hex Lock Nut
Tools required
3/8" Wrench or Socket
7/16" Wrench or Socket
11.3 Close the windshield while lifting up on the bottom
edge. Tighten hinge hardware.
Caution: The windshield hinges are plastic
components. Do not overtighten the flat head
screws. Torque to 7 ft.-lbs. max.
11.4 Ensure the windshield latches function properly and the
windshield pivots open.
11.5 Remove the over tightening caution decal from the top
of the windshield.
STEP 12: (WINDSHIELD WIPER
MOTOR)
12.1 Mount the wiper motor to the windshield. See Figure
12.1. Make sure the wires are above the wiper motor
shaft to prevent pinching the wires when the windshield
is opened and closed, then connect to the wire harness.
NOTE: The wiper arm and blade will be installed in a later
step. The wiper motor should easily clear the cowl, but if
not, loosen the windshield hinges and raise the
windshield to gain some clearance.
CAB INSTALLATION
Qty
4
4
Qty
4
4
5/16-18 Flat
Head Screws
Fig. 11.1 (Windshield)
Fig. 11.2 (Secure Windshield Latches)
Plastic Washer
Rubber Washer
Wire Above
Motor Shaft
Large Collared Bushing
(inside)
1/4-20 x 5/8" Screw
Fig. 12.1 (Windshield Wiper Motor)
11 of 28
5/16-18 Nuts
Hinge Spacers
1/4-20 x 5/8 Screws
1/4-20 Nuts
Hex Nut
Cap
Nut
Steel
Washer
Rubber Washer
Small Collared
Bushing (Inside)
1/4" Int. Tooth Lock Washer
Advertisement
