Delta Elektronika SM3300 Series Product Manual page 23

REMOTE PROGRAMMING
POWER SINK
 Enable / disable Power Sink.
 Enable / disable Power Sink when Remote ShutDown
status is high.
 Enable / disable Power Sink when Interlock status is high.
 Enable / disable Power Sink when the Output is Off.
NETWORK
 DHCP enabled / disabled.
 IP Version.
 Network IP address.
 Network Subnet mask.
 Network Gateway address.
 Network interface MAC address.
INTERFACES (Slot1, 2, 3 and 4)
ISOLATED ANALOG
 Voltage levels on analog programming and monitoring for
output voltage and current.
 Level of Status signals ACF, DCF, PSOL, LIMIT, RSD, OT
and CC.
SERIAL & USB
 Select BUS-type: USB, Differential or RS232.
 Device channel nr.
 Baudrate, Databits, Stopbits, Parity bits.
 Slewrate, Termination, Simplex/Duplex.
DIGITAL I/O
 Level of digital inputs A...H (High / Low).
 Level of digital outputs A...H (High / Low).
ISOLATED CONTACTS
 Status of the relay contact 1...4 (On / Off).
 Level of the Interlock input (High / Low).
 Level of the Enable input (High / Low).
MASTER / SLAVE
 Enable or disable master / slave mode.
 Select Master or Slave.
 Number of units in parallel or series.
SEQUENCES
 Upload sequences into the unit's volatile memory.
 Synchronize memory to copy sequences from the volatile
to the non-volatile memory.
 After switching off the unit, the sequences remain on the
power supply.
 Monitor and make settings:
- View sequencer name
- View if it is loaded as active sequencer
- View if it has been build
- Mark for Non-Volatile
- Set start/stop conditions
- Set if to restore or retain output state and values after it
is terminated
- Mark for deletion
 See paragraph 4 of this chapter for more information
about sequencer programming.
7.2.3 ADMINISTRATION
FIRMWARE
 Here a new firmware package can be uploaded.
INFO
 System information
- Unit.
- Serial number.
- Manufacturer.
- Software version.
- Custom mode
- Internal error.
 Highlight button
- Display on front will blink for about 2 seconds.
- Buzzer on front is on for about 2 seconds.
23 / 30 DELTA ELEKTRONIKA B.V.
SM3300
rev. Jan. 2022