Connecting The Water Heater To The Water Connections; Conventional Connection; Connection With Temperature Limiter - Atlantic CHAUFFEO VS 500L Installation And Operating Manual

EN
Manuel d'installation : Raccordement hydraulique
3. Water heater water connections
The water heater must be connected in accordance with the standards and regulations in the
country in which it is installed (for France: DTU Plumbing 60-1).

3.1 Conventional connection

u
Connect the NEW safety unit to the cold water inlet (blue) on your water heater.
v
Place the siphon under the safety unit and connect its drain pipe to the drain.
w
Tighten the dielectric connection (provided, depending on the version) onto the hot water outlet
(red) on your water heater.
x
Tighten your pipes on your water heater.
Your pipes must be rigid (copper) or flexible (standardised braided stainless steel hoses)
and able to withstand 100°C and 10 bar (1 MPa). Otherwise, use a temperature limiter.
w
Dielectric
connection
MANDATORY
Hot water connection
3.2 Connection with a temperature limiter
If your pipes are made from synthetic materials
(plastic or PER for example), it is essential to fit
a temperature limiter (or thermostatic regulator).
The limiter must never be connected directly
to the water heater.
The temperature limiter enables the risks
of burning to be limited.
26
u
Te on to be
applied in
the direction
of screwing
NEW
safety unit
v
Siphon
MANDATORY
Cold water connection
WARNING
Waste water
drainage
Dielectric
connection
must withstand
100° C and 10 bar
For pipes made from PER
Temp.
limiter
MANDATORY
New and renovated
(decree of 30/11/2005)
ESSENTIAL
Unit
safety
Siphon