System Overview; Nk300Cx Host - WEIHONG NK300CX Manual

1 System Overview

NK300CX Integrated CNC System (Hereinafter referred as to NK300CX) consists
of hardware and software:
Hardware
•

NK300CX host

• Operation panel and keypad panel
– NK300CX-H:
– NK300CX-V:
– NK300CX for Frilling:
• Lambda terminal board
It varies with axes configuration and software functions:
– Lambda 4S: pulse-type, up to 4 axes supported.
– Lambda 5S: pulse-type, up to 5 axes supported.
– Lambda 5E: pulse-type, up to 5 axes and absolute function supported.
– Lambda 5M: bus-type, up to 8 axes and absolute function supported.
• DB9M/F cables
See NK300CX Connection Diagram
Software
Based on an embedded platform, NK300CX software can be divided into the
following:
• Integral software: combine configurations of 3 axes, 4 axes, and 5 axes as a
whole.
• Multi-Z axes software: used for motion control of multi-Z axes, including
linkage configuration, double Y linkage configuration and alternative
configuration.
This section takes integral software under three-axis configuration as an
example.
See Main Software Interface
1.1 NK300CX Host
This part introduces the layout and mounting dimension of NK300CX host.
1.1.1 Layout
It introduces the layout of both front view and rear view.
WH106C operation panel and WH201C keypad panel
WH108C operation panel
WH208A1 operation panel
for how to connect all hardware.
for the introduction for its main software interface.
3 / 53
上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD