Table of Contents
Advertisement
AUX INPUT
This rear panel female BNC connector is for low frequency
(dc to approximately 360 Hz), low voltage measurements.
This input is calibrated for inputs up to f10 V, but will
accept signals up to f15 V. See "Making Measurements with
the Auxiliary Input" in Chapter 3 for more information.
EXT REF IN
This rear panel female BNC connector accepts a
reference. The nominal input impedance is 50 0.
EXT TRIG
This rear panel female BNC connector allows external
triggering of a sweep. When the TTL level is pulled high, a
IN/OUT
sweep is triggered. When the TTL level is pulled to ground,
the sweep is inhibited. This is an open-collector signal
which you can drive low, but must not drive high, since the
analyzer also drives it.
LIMIT TEST
This rear panel female BNC connector provides a
'ITL IN/OUT
bidirectional open-collector TTL high signal. The output
goes high when the limit test passes. The output goes low if
the limit test fails. This is an open-collector signal which you
can drive low, but must not drive high, since the analyzer
also drives it.
N O T E
Limit tasting can be set independently on each of the two measurement channels. If both
measurement channels are being used, and the limit test is ON for both channels, both measurement
channels must pass for the output to go high. See the following table.
Front/Rear Panel
Connectors
8 - 5
Advertisement
Table of Contents
