HP 8712C User Manual page 408

resolution as MHz, kHz, or Hz. For example, a frequency of 1,234,567 Hz can
be displayed as: 1 MHz (note rounding down), 1.235 MHz (note rounding up),
or 1.234 567 MHz. Default is kHz.
concerning type of data to be displayed, split or full screen, title and limit
lines.
(Option 100 only) Softkey available under the m key and the add
max point and add min point menus. Used to perform fault location
measurements. See your Option 100 User's Guide Supplement for
information.
be visible in low level measurements.
See "Reducing Trace Noise" in Chapter 5 for more information.
The measurement calibration must be performed with the same spur avoid
C A U T I O N
option used in the measurement or your results may be invalid.
Access Keys: IrVIENU) $pr~ Avoid Options
Access Keys: a C&1 Check
devices. Toggles with Xon/Xoff .
Access Keys: [HARD] Selsct @oPy Port
Reference
9-23