Table of Contents
Advertisement
Velocity
to calculate equivalent electrical length. Values entered should be less than 1,
however the analyzer accepts values from 0.01 to 1.2.
Access Keys: [CAL) MOZ'B Cal
external monitors. Also affects network analyzer's internal CRT. Default
Back Porch
setting is 31.84 psec. This setting is not affected by an instrument preset.
See "Using an External VGA Monitor" in Chapter 4 for more information.
Access Keys:
external monitors. Also affects network analyzer's internal CRT. Default
setting is 16.68416 msec. This setting is not affected by an instrument preset.
See "Using an External VGA Monitor" in Chapter 4 for more information.
Access Keys:
display on both the internal CRT and an external monitor. Accepts whole
Position
number values from 1 to 100, with 1 representing as far up as possible and
with 100 representing as far down as possible. The default value set at the
factory (and obtained by pressing Restore Defaults ) is 74. This setting is
not affected by an instrument preset.
See "Using an External VGA Monitor" in Chapter 4 for more information on
using an external display.
Access Keys:
9 - 8 6
Reference
(
]
SYSTEM OPTIONS
[
]
SYSTEM OPTIONS
(
]
SYSTEM OPTIONS
CRT Adjust
Advertisement
Table of Contents
