Suspensions
•
Using a hook spanner lock the pump-
ing member pin and tighten the fixing
screw on the fork end to the prescribed
torque.
Specific tooling
020889Y Wrench for locking pumping unit ring
nut
Filling oil
(PROCEDURE FOR OHLINS FORKS)
•
Clamp the forks in a vice using the special tool.
•
Fill the forks with oil until the air bubbles
trapped inside are forced out.
Oil level: 191 mm (7.52 in) (from the edge of the
sleeve, without spring or pre-loading tube).
THE SLEEVE MUST BE PERFECTLY UPRIGHT IN ORDER
TO MEASURE THE CORRECT OIL LEVEL. THE OIL LEVEL
MUST BE THE SAME IN BOTH STANCHIONS.
Characteristic
Oil for forks
421 cc (0,093 Uk gal) (for each shaft)
•
Insert the pre-loading spring while
maintaining the pin in the raised posi-
tion.
SUSP - 412
RSV4 RR-RF