APRILIA RSV4 RR 2017 Service Station Manual page 321

RSV4 RR-RF
•
Pretighten the six nuts on the stud bolts
proceeding in the following order: 1 - 2
- 3 - 4 - 5 - 6.
•
Then tighten them fully following the
same order.
•
Tighten the two screws according to
the sequence (a - b).
•
Fit the camshaft gear
•
Keep the gear in position with the chain
tightened
THE SIDE WITH THE BEVELLED HOLE IN THE TIMING
SYSTEM GEAR MUST ALWAYS FACE THE EXTERIOR OF
THE HEAD.
•
Install both chain sliders and fasten
them with the specific screws.
•
Rotate the crankshaft via the opening on the clutch cover.
•
Position cylinder 1 piston (LH, rear piston) so that it is at the point where it crosses TDC.
Engine
ENG - 321