APRILIA RSV4 RR 2017 Service Station Manual page 146

Electrical system
•
Saved data download / - (saved data download
CAUTION
AFTER CANCELLING ALL THE DATA STORED DURING THE VEHICLE PRODUCTION PHASE
(INCLUDING THE SELF-ADAPTIVE PARAMETERS), THE FOLLOWING MUST BE SELECTED:
HANDLE SELF-LEARNING AND CHECK THE TWO "AUTOMATIC SELF-LEARNING OF THE
FRONT THROTTLE VALVES" AND "AUTOMATIC SELF-LEARNING OF THE REAR THROTTLE
VALVES" STATUSES ARE "CARRIED OUT".
Battery
Function
Provides electrical power to vehicle: the YTZ 10 S
MF battery is already activated, charged and
sealed; or, alternatively, the YT 12A - BS battery
that must be activated and charged.
Level in electrical circuit diagram:
Battery charge
Position:
•
on the vehicle: under the saddle
•
connector: on the battery
Electrical specifications:12 V / 18 Ah
Pin out:
1. Positive pole (red): approx. 12,6 V
2. negative pole (black): ground lead
DIAGNOSTIC TOOL:PARAMETERS
Battery voltage
•
Example value with key ON: 12.0 V
•
Example value with engine on: 14.2 V
This is one of the values set by the ECU in the
event of recovery mode
Battery voltage before prior to Recovery mode
•
Example value with key ON: 12.0 V
•
Example value with engine on: 14.2 V
Value determined from signal read without taking
considering whether recovery mode is implemen-
ted
CAUTION
PAY ATTENTION TO THE POSITIVE BATTERY CABLE,
WHICH MUST PASS BELOW THE UPPER PART OF THE
FRAME.
CAUTION
ELE SYS - 146
RSV4 RR-RF