Related Manuals for GABOR DMS-202
Summary of Contents for GABOR DMS-202
- Page 1 DMS-202 / MAINMAST DUAL DISPLAY DESKTOP MONITOR STAND for 17 to 27 in. Screens User Manual...
- Page 2 Thank you for choosing Gabor. Gabor’s sturdy Mainmast Dual Display Desktop Monitor Stand is a space and clutter saver for desks and workstations at home and in the office. This free-standing desk accessory can hold two monitors, each weighing up to 13.2 pounds, and allow you to adjust the height, swivel, and tilt for the perfect viewing angle.
-
Page 3: Safety Warnings
Safety Warnings • Please read and follow the instructions, and keep this manual in a • Make sure everything is secure before proceeding to the next step. safe place. • Do not exceed the maximum load capacity. • To avoid damage to this product, be careful not to overtighten or improperly thread any of the threaded fittings. -
Page 4: Product Specifications
Product Specifications 73 7 m m Monitor display size Monitor height adjustment 6 75 m m 17 to 27 in. (43.2 to 68.6 cm) range 6.1 in. (15.5 cm) Maximum weight per monitor 13.2 lb. (6 kg) Weight (without monitors) 9.9 lb. - Page 5 Overview Top handle VESA plate Monitor bar Bridge Bridge Lever Tilt tension clamp back screw Lower hand grip Sliders Column Mounting bracket Lever front Cable channel Height lock Base Column hooks...
-
Page 6: Parts Included
Parts Included M4 × 12 mm screws M5 × 12 mm screws D5 washer Base Mounting bracket Sliders Lever back Lever front Column Monitor bar Bridge Bridge clamp Top handle Lower hand grip Hex bolt M4 × 6 mm screw M4 ×... -
Page 7: Assembling The Base
Assembling the Base Attaching the Lever Fit the column (A) Attach the lever back into the base (B). (E) to the height lock with the four screws Screw the hex bolts (M). Use the (L) into the holes in screwdriver end of the bottom of the the 5 mm hex key (S) base using the 6 mm... - Page 8 Inserting the VESA Mounts Assembling the into the Monitor Bar Monitor Bar Place two sliders (D) onto each mounting bracket (C) Slide the left and right as pictured. sides of the monitor bar (G) onto the bridge (H). Make sure the bridge‘s arch is facing down.
-
Page 9: Attaching The Handles
Attaching the Handles Slide the top handle (J) under the base of the lever to align the holes. Note: The handle should curve toward the Use the 4 mm hex key (R) to tighten the monitor arm set screws until secure. back of the stand. -
Page 10: Mounting The Monitor
Mounting the Monitor Before you attach the VESA plate, hand thread one of the M-A or M-B screws to determine which one fits your monitor. Make sure the screw is also not too long or too short. If the screw is too long, it may damage the display. If it’s too short, it may not hold it. 100 ×... -
Page 11: Cable Organization
Cable Organization Monitor Tilt, Rotation, and Swivel Swivel Tilt After the monitors are installed, keep your cables neat and organized by running them For optimum monitor To adjust the through the cable channel in the center column. position, the column viewing angles, tilt swivels 40°... - Page 12 To obtain warranty coverage, contact the Gabor Customer Service Department to obtain a return merchandise authorization (“RMA”) number, and return the defective product to Gabor along with the RMA number and proof of purchase. Shipment of the defective product is at the purchaser’s own risk and expense.