Lennox LNINVE052 Service Manual page 94

Service Manual
Step
9. Remove stepping motor
Remove the screw fixing step motor and
then remove the step motor.
10. Remove motor and cross flow blade
a
Remove the screws fixing motor clamp
and then remove the motor clamp.
b Remove the screws at the connection
place of cross flow blade and motor; lift
the motor and cross flow blade upwards
to remove them.
c Remove the bearing holder sub-assy.
Installation and Maintenance
Procedure
Screws
Holder sub-assy
Step motor
Screws
Motor clamp
Cross flow
Motor
Bottom case
91