Lennox LNINVE052 Service Manual page 104

Service Manual
Step
6.remove the soundproof sponge.
Tear off the sticking stripe and then remove the
soundproof sponge.
7.remove the isolation plate and reactor
Remove the 2 screws connecting the isolation
a
plate and condenser side plate; remove the
3 screws connecting the isolation plate and
chassis, and then remove the isolation plate.
Remove the 4 screws connecting the reactor
b
and isolation plate, and then remove the reactor
Installation and Maintenance
Procedure
soundproof
sponge
screw
isolation plate
screw
reactor
sticking
stripe
screw(Note: these two screws are
at the side of motor support)
screw
101