Product Safety Information; Product Specifications; Installation And Lubrication - Ingersoll-Rand 2955B2 Product Information

Product Safety Information

Intended Use:
These Air Impact Wrenches are designed to remove and install threaded fasteners.
For additional information, refer to Product Safety Information Manual Form 04580916.
Manuals can be downloaded from ingersollrand.com

Product Specifications

Model Style
Type
Inside
2955B2 Square 1.5"
Trigger
Model
† Pressure (L
2955B2 98.2
† K = 3dB measurement Uncertainty
pA
‡ K = 3dB measurement Uncertainty
wA
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 47132600 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
6. Thread size
TL-2955-PIM_ed1
Drive
Impacts
per min.
Size
700
Sound Level dB(A)
(ISO 15744)
) ‡ Power (L
p
109.2
WARNING
7.
8.
9.
10. Grease - during assembly
11. Grease - through fitting
Recommended Torque Range
Forward
ft-lb (Nm)
1600-3750 [4500 Max]
(2170-5100 [6100 Max])
)
w
* K = Vibration measurement uncertainty
Coupling
Safety Air Fuse
Oil
Reverse
ft-lb (Nm)
1600-3750 [4500 Max]
(2170-5100 [6100 Max])
Vibration (m/s )
2
(ISO 28927)
Level *K
18 4
EN
EN-1