Related Manuals for Ingersoll-Rand 2945
Summary of Contents for Ingersoll-Rand 2945
- Page 1 Form 04584306 Edition 1 April 2005 Air Impact Wrench 2945 and 2950 Maintenance Information Save These Instructions...
- Page 2 Lubrication Each time a Series 2945 or 2950 Super Duty impactool is disassembled around the Hammer Case Bushing (41). Inject approximately 4 cc of for maintenance and repair or replacement of parts, lubricate the tools as grease into the Grease Fitting (2).
- Page 3 to handle end of Housing. Grasping Housing with installed screws Disassembly of the Handle downward, sharply strike heads of screws on a sturdy table to Clamp Trigger Handle Assembly in a copper-covered or leather- dislodge Cylinder. Cylinder should drop out of Housing after a few covered vise jaws with Straight Inlet (10) upward.
-
Page 4: Troubleshooting Guide
Assembly of Impact mechanism NOTICE If you are installing new Hammers, or want to change the location of the existing Hammers to utilize both impacting surfaces, slide the Hammers in the Hammer Frame so that the half-round notch on one Hammer is located on one side of the Frame and the half-round notch on the other Hammer is located on the other side of the Frame. - Page 5 Notes Form 04584306-Edition 1...
- Page 6 Notes Form 04584306-Edition 1...
- Page 7 Notes Form 04584306-Edition 1...
- Page 8 www.irtools.com Ingersoll-Rand © 2005 Company...