Nexti; Run To Cursor Line - Wiznet W7100 Debugger User Manual

Hide thumbs Also See for W7100 Debugger:

Table of Contents

command enters into the related Function. After the execution, the debugger is stopped and

waits for the next command.

To use this command click the

Stepi. It can also be done by short key F7.

Nexti

The Nexti command executes one instruction. But the command does not enter into the

related Function even if the instruction is a Function call. After its execution, the debugger is

stopped and waits for next command.

To use this command click the

It can also be done by short key F6.

The 'Run to cursor line' command executes the code until the cursor on the debugger source

window is met.

To use this command, select the push the mouse right button => select 'Run To Cursor Line(n)'

or select the Debug Menu => Run To Cursor Line.

Sometimes the 'Run To Cursor Line' command continues when the cursor is not properly set.

If that is the case, execute the Stop command to stop it.

button on the toolbar or select the Debug menu =>

button or select the Debug menu => Nexti.

[Fig.5.8] Run To Cursor Line command

Table of Contents