Replacing The Lithium Battery - Kontron Embedded Computers KISS 4U User Manual

Replacing the Lithium Battery

The integrated motherboard or SBC-board of your system is equipped with a
lithium battery. To replace the battery, please proceed as follows:
1. Open the unit as described in the "Installing/Removing the Expansion Cards"
chapter (step 1-4).
2. If your system has expansion cards, first remove the cards and their
corresponding data cables in order to have access to the lithium battery.
3. Remove the old battery by pressing outwards on the ejector spring.
4. Place the new battery into the socket.
5. Make sure that you insert the battery the right way around. The plus pole must
be on the top!
6. The lithium battery must be replaced with an identical battery or a battery type
recommended by Kontron Embedded Computers. The Lithium battery type
must be UL listed.
7. Reinstall the expansion cards which you removed and reconnect their data
cables.
8. Close the Unit as described in chapter "Installing/Removing the Expansion
Cards" (step 5-8).
Caution
Danger of explosion when replacing with wrong type of battery.
Replace only with the same or equivalent type recommended by
the manufacturer. The Lithium battery type must be UL listed.
Do not dispose of lithium batteries in general trash collection.
Dispose of the battery according to the local regulations dealing
with the disposal of special materials, (e.g. at the designated
collecting points for dispose of batteries).
KISS 4U - User's Manual (V1.10)
Maintenance and Prevention
41