Table of Contents
Advertisement
Assembly, Disassembly
1
Fig. 21: Bolts and fastening point for the card hold-down bracket
3
Fig. 22: card hold-down bracket
5. Put/pull the expansion card into/out from the expansion card slot of the
backplane/motherboard and fasten the mounting bracket of the expansion
card/filler bracket to the rear slot of the device.
6. Reinstall the card holder and secure it using the retaining screw (see Fig. 20).
7. The PCP holder (refer to Fig.: 20, Fig. 22, pos. 4) has to be installed into the
appropriate hole of the card hold-down bracket by means of the provided
screw, if necessary. Fix the upper edge of the expansion card (especially for
full-length card) into the slot of the PCB holder (height adjustable). Thus the
card is firmly kept in place during high mechanical load (shock and vibrations).
8. Close the KISS 4U-Platform and secure the cover with the captive knurled
screws.
30
Legend for figures: 20, 21 and 22:
5
4
1
Bolts for the card hold-down bracket
2
Threaded bolt
3
Locating holes
4
PCB holder
5
Hole for the fastening screw
KISS - User's Manual (V1.10)
2
Advertisement
Table of Contents
