Wiring; Figure 6-6: Wiring Of Tsm - NBN Fluke CS400 Hardware Manual

CS400 System
Hardware Manual, Rev. 1.0, Sep 2021

6.3.6 Wiring

For the detailed wiring of the TSM see section 8.7
For recommended cables see section 3.5
The position indicator for the kiln (master) must be wired to the <kiln trigger> labeled input on the terminal line of
the TSM remote control box! All subsequent TSM position indicators must be wired to the inputs <Ring 1>,
40

Figure 6-6: Wiring of TSM

Position
Indicator
Position
(TSM)
Indicator
(TSM)
Junction
Box
Junction
Box
TSM –
Wiring, page 54.
Cable Requirements, page 19.
Note
<Ring 2> and so.
Position
Indicator
(Kiln)
Position
Indicator
(TSM)
Junction
Box
Junction
Box