Table of Contents
Advertisement
The trigger signal is only required if the accessory Tire Slip Monitoring is not used!
Kiln axis
Trigger bar
Adjustment of the position indicator:
1.
Mount the trigger bar.
2.
Mount the position indicator mounting plate.
3.
Check the distance between position indicator and trigger bar.
Lock the position indicator in place and monitor its' operation. With each revolution of the kiln you should
4.
obtain a trigger pulse indicated by an LED in the junction box (field).
4.5 Fiber Optic Converter Box
The Fiber Optic Converter Box is in the control room and connects the fiber optic cable from the field to the Ethernet
interface of the computer. For more technical data, see section 9.2
Note
Figure 4-7: Mounting the Position Indicator
Rotation
Kiln
Trigger bar
steel St37, sized 50 mm in
square (2.16 in. in square)
Distance: max. 20 mm (0.79 in.)
Position indicator with
mounting plate
PTFE cable, 5 m (15 ft.)
Junction box
Cable W8 to system connection box
Connection
Box, page 61.
Installation
4
Fiber Optic Converter Box
27
Advertisement
Table of Contents
