Table of Contents
Advertisement
b) RS-232C Interface:
Communication Method: Full Duplex
Communication Rate:
Transmission Method:
OSD (On Screen Display) Operation
1) Menu button:
Push Menu button, and following screen will apear.
2) PRESET:
You can set 64 different Zoom/Focus positions.
How to preset:
a) First, obtain the desired picture by using "ZOOM" and/or "FOCUS".
b) Then, go back to "Main Menu", and select "PRESET".
c) Push "Enter" twice and select "Position" 1 through 64, and push "Enter".
d) Move the cursor down to "SET" and push "Enter".
e) Repeat a) to d) to set Max. 64 positions.
f) to operate the Preset position:
f-1) Select "PRESET", and push "Enter" twice.
f-2) Select Position (1 through 64) by "UP" or "DOWN" button, and push "Enter".
f-3) Move the cursor down to "RECALL" and push "Enter".
f-4) Repeat f-1) to f-3) to choose other positions.
Pin No.2/3/5
9600bps
bit serial (binary data)
8 bit fixed
start bit=1, stop bit=1
No parity bit
EG-5
Communication protocol: start/stop system,
Error Recovery:
Flow Control:
Blinking title is your choice at
present. The blinking item
goes up and down by pushing
"UP"/"DOWN" buttons. After
selecting the title, push "Enter"
to set.
After you finish your settings,
push "Menu" button to exit.
Push "Cancel" button to go
back to Main Menu while
adjusting.
original process
No error detection,
Re-transmission
by PC
No
Advertisement
Table of Contents
