SunStar KM-2510A Manual/Parts Book page 18

To get the most out of the many functions of this machine and operate it insafety,it is necessary to use this
machine correctly.
Please read this Instruction Manual carefully before use.We hope you will enjoy the use of your machine for
a long time.
Please remember to keep this manual in a safe place.
1. Observe the basic safety measures,including,but not limited to the following ones, whenever you use
the machine.
2. Read all the instructions, including, but not limited to this Instruction Manual before you use the machine,
in addition, keep this Instruction Manual so that you may read it at anytime when necessary.
3. Use the machine after it has been ascertained that it conforms with safety rules/standards valid in your
country.
4. All safety devices must be in position when the machine is ready for work or in operation The operation
without the specified safety devices is not allowed.
5. This machine shall be operated by appropriately-trained operators.
6. For your personalprotection,we recommend that you wear safety glasses.
7. For the following, turn off the power switch of disconnect the power plug of the machine from the rece-
ptacle.
7-1 For threading needle(s) and replacing bobbin.
7-2 For replacing part(s) of needle, presser foot, throat plate, feed dog, cloth guide etc.
7-3 For repair work.
7-4 For when leaving the working place of when the working place is unattended.
8. If you should allow oil, grease, etc. used with the machine and devices to come in contact with your
eyes or skin or swallow any of such liquid by mistake, immediately wash the contacted areas and consult
a medical doctor.
9. Tampering with the live parts and devices, regardless of whether the machine is powered, is prohibited.
10. Repairing,remodeing and adjustment works must only be done by appropriately trained technicians or
specially skilled personnel.
11. General maintenance and inspection works have to be done by appropriately trained personnel.
12. Repair and maintenance works of electrical components shall be conducted by qualified electric technic-
ians or under the audit and guidance of specially skilled personnel. Whenever your find a failure of any of ele-
ctrical components, immediately stop the machine.
13. Periodically clean the machine throughout the period of use.
14. Grounding the machine is always necessary for the nomal operation of the machine. The machine has
to be operated in an enviorment that is free from strong noise sources such as high-frequency welder.
15. An appropriate power plug has to be attached to the machine by electric technicians, Power plug has to
be connected to grounded receptacle.
INSTRUCTION MANUAL
6 18